The whole wheel loader is mainly composed of power system, transmission system, working device, working hydraulic system, steering hydraulic system, frame, operating system, braking system, electrical...
The correct operation steps of the wheel loader First, check the vehicle: 1. Check the fuel, cooling water and lubricating oil. 2. Check the reliability of driving and parking brakes. 3. Check the ope...
The air-conditioning system and anti-rollover and falling object protection devices are not available in the first generation, but are newly added in the second product, mainly to increase safety and ...
After the 3 ton forklift has been repaired, the purpose of its inspection is to verify whether the performance of the forklift has returned to normal. The test should be carried out on a hard and flat...
Once the steering system of the forklift fails, it will directly affect the safety of the driving operation, so it should be eliminated immediately when the fault is found. How to diagnose and repair ...
Precautions and routine inspections for daily maintenance of 5-ton wheel loaders: 1. General requirements for maintenance of loaders 1. Park the loader on a level ground; 2. Put the gearbox control le...
Forklift overhaul content and acceptance criteria First, what does the forklift overhaul include? The items that must be completed for a forklift overhaul mainly include: dismantling the whole vehicle...
Introduction to 7 ton forklift controller 1. The rated value of the forklift controller is as follows: 1. Controller assembly: power supply voltage DC 48V; maximum current: 25A; operating temperature:...
The hydraulic system of the 10 tons forklift is noisy when it is working, and the pressure is high and low, and the failure of instability can be diagnosed from the following points. 1. The oil inlet ...
First, the load roller (bearing) adjustment of the 3 ton new forklift frame. NOTE: Standard, Full Free Lift and Full Free Triple Lift Fork Carrier Bearings are all adjusted in the same manner. Shown b...
1. What are the reasons why the articulated loader diesel engine "boils"? How to eliminate and prevent? "Boiling" refers to the phenomenon that the temperature of the diesel engine is too high and the...
How to perform loader repair and maintenance? To do a good job in the daily maintenance and upkeep of the loader, you must start by understanding the working conditions of each system every time you d...
IPv6 network supported 
